As the core power equipment of a fertilizer production line, a horizontal crusher requires adequate daily maintenance, which directly impacts its operating efficiency and service life.
- Regular Inspection of Core Components
Stop the horizontal crusher weekly to inspect the condition of the impellers. If the wear-resistant teeth at the end of the impellers are worn more than 1mm or cracked, they should be replaced promptly. Check the main shaft bearings monthly by touching the bearing seat. If the temperature exceeds 60°C or there is any abnormal noise, disassemble and clean the bearings and refill with high-temperature resistant grease. Check the grinding chamber liner quarterly. If the liner is severely worn or dented, replace it to ensure a tight seal.
- Thorough Cleaning
After each production run, the pulverizing chamber must be cleaned of any residual material (especially after handling high-moisture materials). Compressed air or a special scraper can be used to prevent material agglomeration and corrosion of the chamber walls and impellers. The horizontal crusher casing and motor cooling holes should be cleaned monthly to prevent dust accumulation that could affect motor heat dissipation and cause overload and burnout. Quarterly, the seals at the feed and discharge ports should be inspected. If any seals are aged or deformed, they should be replaced promptly to minimize dust leakage.
- Standardized Operations to Reduce Losses
Adjust the feed rate strictly according to the characteristics of the raw materials to avoid overloading. If the raw materials to be pulverized need to be changed (for example, from fibrous to hard materials), the residual material in the chamber must be cleared before adjusting the impeller speed and screen. Spare parts should be kept on hand to avoid prolonged downtime due to a shortage of parts in the event of a malfunction.
